Discover Host-Sas-Addresses - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > discover host-sas-addresses

discover host-sas-addresses

This command displays a list of the SAS addresses that have been discovered for the specified SAS interface
port(s).
■ Syntax
discover host-sas-addresses [-port {
■ Parameter
-port
■ Output
# 500605b000b5f144
A
A: The discovered SAS Address
■ Example(s)
The following example displays a list of the SAS Addresses discovered for all the SAS interface ports on both
CMs:
CLI> discover host-sas-addresses -port all
CM#0 CA#0 Port#0
500605b000b5d8e4
500605b000b5e004
CM#1 CA#0 Port#0
500605b000b5f144
500605b000b5f244
500605b000b5f344
xyz
|all}]
Optional. This parameter specifies the SAS interface port(s) whose discovered host SAS
addresses are to be listed. If this parameter is omitted, the hosts discovered for all SAS host
interface ports are displayed.
Example: -port 000,100
For details, refer to "1.2.14 Host Interface Port Syntax" (page
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the SAS port
number.
Example: "123" indicates CM#1-CA#2-SAS Port#3
all All the SAS interface ports (default)
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
239
25).
P2X0-1030-09ENZ0