Fujitsu ETERNUS DX80 S2 Cli User's Manual page 418

Chapter 4 Function/System Settings and Display
4.2 Advanced Copy Management
3
Associate REC buffer with REC disk buffer.
To associate an REC buffer with an REC disk buffer, use the "set rec-disk-buffer" command.
• To release the REC disk buffer from the REC buffer, use the "release rec-disk-buffer" command. This
can be confirmed by using the "show rec-disk-buffer" command.
• To delete an REC disk buffer, use the "delete rec-disk-buffer" command.
The following figure shows the process involved in setting the REC disk buffer through CLI:
REC buffer
partition 2
set rec-disk-buffer
(Association)
release rec-disk-buffer
(Release)
create rec-disk-buffer
Use four disks
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
Create one volume at the same time
that the REC disk buffer is created.
Volume
REC Disk Buffer
delete rec-disk-buffer
"RECDB0001"
400 401 423
500 501 523
418
End of procedure
format rec-disk-buffer
P2X0-1030-09ENZ0