Fujitsu ETERNUS DX80 S2 Cli User's Manual page 198

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set fc-parameters
-reset-scope Optional. This parameter specifies the range of reset action. If omitted, the existing setting is
-reserve-cancel
-rec-line-no Optional. This parameter specifies the REC line number. If omitted, the existing setting is not
-rec-transfer-sync
-rec-transfer-stack
-rec-transfer-consistency
-rec-transfer-through
not changed. If the RA, Initiator mode is set, this parameter cannot be specified.
initiator-lun Reset (Cancel) the command request from the server that sent the command
reset request.
target-lun Reset (Cancel) the command request from all servers that are connected to the
port (regardless of whether the LUN is recognized).
Optional. This parameter specifies whether or not SCSI reservation (persistent reservation) is
canceled when host interface ports are reset. If omitted, the existing setting is not changed. If
the RA mode is set for the specified port, this parameter cannot be specified.
enable Reservations are canceled.
disable Reservations are not canceled.
changed. This parameter can be specified only when the RA mode or CA/RA auto mode is used.
0 – 127 Specify the REC line number.
Optional. This parameter specifies the synchronous mode for the copy transfer mode. If
omitted, the existing setting is not changed. This parameter can be specified only when the RA
mode or CA/RA auto mode is used.
enable An REC in synchronous transfer mode is permitted for the target CA port.
disable An REC in synchronous transfer mode is suppressed for the target CA port.
Optional. This parameter specifies the asynchronous stack mode for the copy transfer mode. If
omitted, the existing setting is not changed. This parameter can be specified only when the RA
mode or CA/RA auto mode is used.
enable An REC in asynchronous stack mode is permitted for the target CA port.
disable An REC in asynchronous stack mode is suppressed for the target CA port.
Optional. This parameter specifies the asynchronous consistency mode for the copy transfer
mode. If omitted, the existing setting is not changed. This parameter can be specified only
when the RA mode or CA/RA auto mode is used.
enable An REC in asynchronous consistency mode is permitted for the target CA port.
disable An REC in asynchronous consistency mode is suppressed for the target CA port.
Optional. This parameter specifies the asynchronous through mode for the copy transfer mode.
If omitted, the existing setting is not changed. This parameter can be specified only when the
RA mode or CA/RA auto mode is used.
enable An REC in asynchronous through mode is permitted for the target CA port.
disable An REC in asynchronous through mode is suppressed for the target CA port.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
198
P2X0-1030-09ENZ0