Fujitsu ETERNUS DX80 S2 Cli User's Manual page 575

Chapter 4 Function/System Settings and Display
4.4 Miscellaneous > show power-synchronization
K: The signal polarity that controls the UPS output stop signal when the shutdown is complete (This item is
displayed only for the ETERNUS DX80 S2/DX90 S2).
L: It shows whether the UPS output stop signal is enabled or not when the shutdown is complete (This item is
displayed only for the ETERNUS DX80 S2/DX90 S2).
■ Example(s)
The following example displays the settings that control how the shutdown function interacts with the
external sensor (for the ETERNUS DX80 S2/DX90 S2):
CLI> show power-synchronization
Controller Module #0
Controller Module #1
Auto Power
Resume Power
Waiting Time to Shutdown
Type
Power Fail Signal
Low Battery Signal
UPS Shutdown Signal
UPS Shutdown
The following example displays the settings that control how the shutdown function interacts with the
external sensor (for the ETERNUS DX410 S2/DX440 S2):
CLI> show power-synchronization
Controller Module #0
Controller Module #1
Auto Power
Resume Power
The following example displays the settings that control how the shutdown function interacts with the
external sensor (for the ETERNUS DX8700 S2):
CLI> show power-synchronization
Service Controller #0
Service Controller #1
Auto Power
Resume Power
Enable
Disable
Enable
Disable
5 min.
Power Synchronized Unit
Positive
Negative
Negative
Enable
Enable
Disable
Enable
Disable
Enable
Disable
Enable
Disable
575
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0