Chapter 5 Information Settings and Display
5.4 Utility > set led
set led
This command turns the specified LED(s) either on or off.
■
Syntax
set led -target { ce | disk | svc0 | svc1 | opnl } [ -disks
■
Parameter
-target
-disks
-led
■
Example(s)
The following example turns on the LEDs of all the components in DE#1:
CLI> set led -target disk -disks 001,002 -led on
This parameter specifies which enclosure will have all of the LEDs turned on or off.
When "-target disks" is specified, the "-disks" parameter must also be specified.
ce
All components in the controller enclosure
disk
Only the specified disks
svc0
Only SVC#0 (Only for ETERNUS DX8700 S2)
svc1
Only SVC#1 (Only for ETERNUS DX8700 S2)
opnl
Only the operation panel (Only for ETERNUS DX8700 S2)
Optional. This parameter specifies which disks LED are turned on or off. Multiple disks can be
specified at the same time. For details, refer to
This parameter specifies whether the specified LEDs are turned on or off.
on
Turn on the LED
off
Turn off the LED
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
disks
] -led { on | off }
"1.2.3 Disk Syntax" (page
666
19).
P2X0-1030-09ENZ0