Convert Rec-Path - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 4 Function/System Settings and Display
4.2 Advanced Copy Management > convert rec-path

convert rec-path

This command is used to convert the type of the REC path information file to the file type that is saved on and
to an FTP server by passing it through the storage system. This conversion only affects the REC path
information file on the FTP server, and has no effect on the current system setup.
ETERNUS DX
Disk storage system
Conversion
Logic
• If the same file on an FTP server already exists, it would be overwritten.
• If a TEXT type path information file has syntax errors, the number of the problem line is included with the
error message.
■ Syntax
convert rec-path -port {maintenance | remote | fst} -server
login_user_account
-user
-mode {t2b | b2t} [-indicator {enable | disable}]
■ Parameter
-port
-server
-user
source_file
-source-file
This parameter specifies which Ethernet port is used to connect to the FTP server. For details,
refer to "1.11 Note for Specifying FTP Server" (page 31)
maintenance
MNT port
remote RMT port
fst FST port
Both a conversion source file and a conversion destination file must be in an FTP server. This
parameter specifies the FTP server name. The server name format is IPv4 standard notation (a
base 256 "d.d.d.d" string) or a fully qualified domain name.
Example: -server 192.168.1.20
Example: -server foo.bar
This parameter specifies the user name that is to be used to access the FTP server. When this
parameter is specified, the command displays an FTP server password prompt.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
FTP server
input file
TEXT
output file
BINARY
server_name
output_file
-output-file
430
P2X0-1030-09ENZ0