Fujitsu ETERNUS DX80 S2 Cli User's Manual page 689

Appendix A Error Messages
Message
number
E0014
E0015
E0019
E0020
E0021
E0030
E0031
E0032
E0033
E0034
E0035
E0041
E0042
E0050
E0051
E0052
Inconsistent disk status.
Cannot execute the specified command because the disk is not in an appropriate state. Check the status
of the disks identified in the details of this message.
Inconsistent enclosure status.
Cannot execute the specified command because the enclosure is not in an appropriate state. Check the
status of the disks identified in the details of this message.
Inconsistent parameter.
The specified parameter does not correspond with the command. Check the parameters indicated in the
details of this message.
Internal error.
An internal error has occurred. Retry the command, and if unsuccessful, contact the support department.
The requested operation has failed.
The specified command process has failed. If this error continues to recur even after numerous command
retries, the specified command cannot be executed for an unknown reason.
Command not supported.
This command is not supported. Check the execution conditions (Example: model type, host interface
type (FC/SAS/iSCSI), and firmware levels).
Reserved keyword is used.
Reserved keyword cannot be used. Use another name.
Controller firmware cannot be downgraded.
Reverting to an earlier version is not allowed for the hot application mode. Confirm the controller
firmware version by using the "show firmware" command, and use the cold application mode if necessary.
Not applicable to this target.
The specified resource cannot be applied to the specified command process. Check the specified resource.
Mainframe resources.
The specified Mainframe resource cannot be applied to the specified command process. Check the
specified resource.
Disk firmware can only be upgraded.
Confirm the firmware version that is registered in the ETERNUS Disk storage system and the firmware
version that has been applied to the disks. The disk firmware that is currently being used can only be
upgraded to a newer version.
Incorrect password syntax.
The syntax of the specified password is incorrect. Check that the length and characters of the passwords
are acceptable.
Incorrect password.
The password entered is incorrect. Check and then re-enter the password.
Incorrect file.
The specified file format is incorrect. Check the format of the file identified in the details of this message.
Incorrect license key.
The specified license key is incorrect. Check the license key shown in the details of this message.
File access failure.
Unable to access the specified file. Possible causes include file restrictions, directory restrictions or a lack
of free space when creating a file.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
Message
Countermeasure for the error
689
P2X0-1030-09ENZ0