Fujitsu ETERNUS DX80 S2 Cli User's Manual page 455

Chapter 4 Function/System Settings and Display
4.3 Network Management > set network
-gateway
-allow-ip1
. . .
-allow-ip16
Optional. This parameter specifies the gateway address for the specified Ethernet port. This
setting is required to permit access beyond the local sub-network (the sub-network to which
the system network addresses belong). The format is IPv4 standard notation (a base 256
"d.d.d.d" string) or IPv6 address format. The types of IPv6 addresses that can be specified are
local link addresses, global unicast addresses (including 6to4 addresses), and unique local
unicast addresses. If omitted, the existing setting is not changed. This parameter can only be
specified when "v6" is specified for the "-ip-format" parameter and "disable" is specified for the
"-ipv6-set-auto" parameter, or when "v4" is specified for the "-ip-format" parameter.
Example: -gateway 10.1.1.2
Example: -gateway 2001:df:a012::3bbd
This parameter cannot be specified when "-port fst" is specified.
Optional. These parameters specify IP addresses or network addresses that are permitted to
connect to this system. A maximum of 16 IP addresses can be specified. The types of IPv6
addresses that can be specified are global unicast addresses (including 6to4 addresses) and
unique local unicast addresses. If omitted, no changes are made to the table of allowed
addresses. This setting is not required to allow connection from the local sub-network (sub-
network to which the system network addresses belong). This parameter can only be specified
when "v6" is specified for the "-ip-format" parameter and "disable" is specified for the "-ipv6-
set-auto" parameter, or when "v4" is specified for the "-ip-format" parameter. This parameter
cannot be specified when "-port fst" is specified.
The following are examples.
Example: Specify the following parameter to only permit access from a terminal host that has
the IP address "192.168.1.2":
"-allow-ip1 192.168.1.2"
Example: Specify the following parameter to only permit access from a terminal host that has
the IP address "2001:d53:c51::78:332"
"-allow-ip1 2001:d53:c51::78:332"
Example: Specify the following parameter to permit access from all terminals that have an IP
address range of "192.168.3.1" to "192.168.3.254":
"-allow-ip1 192.168.3.0,255.255.255.0"
Example: Specify the following parameter to permit access from all terminals that have a
network address range of "2001:d53:c51:78::/64":
"-allow-ip1 2001:d53:c51:78::,64"
Example: Specify the following parameter to delete an IP address:
"-allow-ip1 0.0.0.0" (IPv4)
"-allow-ip1 0,0" (IPv6)
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
455
P2X0-1030-09ENZ0