Fujitsu ETERNUS DX80 S2 Cli User's Manual page 3

This manual describes how to use the Command Line Interface (CLI) to configure and manage a RAID system
using the FUJITSU Storage ETERNUS DX80 S2/DX90 S2 Disk storage system, ETERNUS DX410 S2/DX440 S2 Disk
storage system, or ETERNUS DX8100 S2/DX8700 S2 Disk storage system.
This manual is written for standard-level users who are familiar with the basic functions of the FUJITSU Storage
ETERNUS DX80 S2/DX90 S2 Disk storage system, ETERNUS DX410 S2/DX440 S2 Disk storage system, or
ETERNUS DX8100 S2/DX8700 S2 Disk storage system.
This manual is written for controller firmware version V10L50 or later. Some of the functions herein may not
be supported for firmware version V10L4x or earlier.
Note that the FUJITSU Storage ETERNUS DX80 S2/DX90 S2 Disk storage system, ETERNUS DX410 S2/DX440 S2
Disk storage system, and ETERNUS DX8100 S2/DX8700 S2 Disk storage system are represented as ETERNUS DX
Disk storage system in this document.
Content and Structure
This manual contains the following six chapters and appendices:
●
Chapter 1 Overview
This chapter introduces the ETERNUS DX Disk storage system Command Line Interface (CLI).
●
Chapter 2 Status Display
This chapter explains the commands used for displaying the status details for the ETERNUS DX Disk storage
system as a whole, as well as for various ETERNUS DX Disk storage system components.
●
Chapter 3 Configuration Settings and Display
This chapter explains the commands used for Thin Provisioning management, RAID group management,
volume management, and host interface management, these being the basic settings for the ETERNUS DX
Disk storage system.
●
Chapter 4 Function/System Settings and Display
This chapter explains the commands used for user account management, advanced copy management,
network management (Redundant IP/SNMP etc.), date and time/NTP, system configuration (Box ID,
Storage system name), power synchronization, and SSH/SSL security configuration.
●
Chapter 5 Information Settings and Display
This chapter explains the commands used to provide performance data and a variety of other information.
3
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
Preface
Ninth Edition
August 2015
P2X0-1030-09ENZ0