Fujitsu ETERNUS DX80 S2 Cli User's Manual page 209

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set iscsi-parameters
-host-affinity
-iscsi-name Optional. This parameter specifies the iSCSI name for the specified host interface port. If
-alias-name Optional. This parameter specifies an alias to the iSCSI name that corresponds to the "-iscsi-
-host-response-number
or
-host-response-name
-reset-scope
-reserve-cancel
Optional. This parameter specifies the Host Affinity Mode. If omitted, the existing setting is not
changed. Host affinity is a security mechanism used to restrict access by a given host to only a
specific set of LUNs. This parameter cannot be specified when the port is set to the RA mode.
enable Host Affinity Mode is enabled.
disable Host Affinity Mode is disabled.
omitted, the existing setting is not changed. This parameter cannot be specified for iSCSI-RA,
which is only used for connecting older models.
• Up to 223 alphanumerical characters including, hyphen minus (-), full stop (.), and colon
(:), can be used to specify this parameter.
• "iqn." or "eui." must be added in front of the character string.
• Characters are not case-sensitive.
name" parameter. A maximum of 31 alphanumeric characters can be used. The available
characters are the ones that is shown in
a comma (,). Specify consecutive double quotations (-alias-name "") for this parameter to
remove the alias name.
This name is not used for control purposes. It is only handled as a comment corresponding to
the iSCSI name.
Optional. This parameter specifies the host response identifier. Only one identifier can be
specified at any given time. If omitted, the existing setting is not changed. For details, refer to
"1.2.12 Host Response Syntax" (page
set to the RA mode.
Optional. This parameter specifies the range of reset action. If omitted, the existing setting is
not changed. This parameter cannot be specified when the port is set to the RA mode.
initiator-lun Reset (Cancel) the command request from the server that sent the command
reset request.
target-lun Reset (Cancel) the command request from all servers that are connected to the
port (regardless of whether the LUN is recognized).
Optional. This parameter specifies whether or not reservations are canceled when a host
interface port is reset. If omitted, the existing setting is not changed. This parameter cannot be
specified when the port is set to the RA mode.
enable Reservations are canceled.
disable Reservations are not canceled.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
"1.2.2 Keywords and Parameters" (page
24). This parameter cannot be specified when the port is
209
19), except for
P2X0-1030-09ENZ0