Fujitsu ETERNUS DX80 S2 Cli User's Manual page 588

Chapter 4 Function/System Settings and Display
4.4 Miscellaneous
5
Create a key group.
Use the "create sed-key-group" command to create a key group.
• Use the "create sed-key-group" command to change a key group.
• Use the "delete sed-key-group" command to delete a key group.
6
Import the SSL/KMIP certificate.
Use the "import ssl-kmip-certificate" command to register the server certificate that is signed by a
certificate provider to the ETERNUS DX Disk storage system.
7
Update the SED authentication key.
Use the "change sed-key" command to update the SED authentication key for the key group.
If no SED authentication key is registered in the key group, an error occurs when the first update of the
SED authentication key is performed. In this case, register the SSL self-signed certificate of the
ETERNUS DX Disk storage system in the key server, accept access from the ETERNUS DX Disk storage
system, and then update the SED authentication key again. The "Key Status" changes to "Normal".
8
Check the key server status.
Use the "show sed-key-groups" command to check the key server status.
9
Set the key group for a RAID group.
Use the "set raid-group" command to enable the key management server linkage function for a RAID
group.
588
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
End of procedure
P2X0-1030-09ENZ0