Create Port-Group - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > create port-group

create port-group

This command creates port groups.
• A port group can be created even when the same ports that belong to an existing port group are to be
specified for the port group.
• A port group can be created even when mapping is already set for all of the specified ports that are in
different groups.
• A port group can be created even when the specified port does not belong to a port group and the host
affinity (LUN mapping) is already set for the port.
• Ports with host affinity "disabled" cannot belong to a port group.
• Up to eight ports can be set for a single port group.
■ Syntax
create port-group -name
■
Parameter
-name
-port
■
Example(s)
The following example creates the port group named "PG0001". The following example sets the parameters
to control FC interface port #1 on CM#0 CA#0 and FC interface port #1 on CM#0 CA#1:
CLI> create port-group -name PG0001 -port 001,011
name xyz
{-port
This parameter specifies a name of the port group. Only one name can be specified at the
same time. For details, refer to
This parameter specifies the host interface port. Two or more parameters can be specified by
separating them with a comma.
Example: -port 000, 011
For details, refer to "1.2.14 Host Interface Port Syntax" (page
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the port
number.
Example: "123" indicates CM#1-CA#2-Port#3
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
}
"1.2.4 Alias Name Syntax" (page
311
20).
25).
P2X0-1030-09ENZ0