Set Advanced-Copy-Parameters - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 4 Function/System Settings and Display
4.2 Advanced Copy Management > set advanced-copy-parameters

set advanced-copy-parameters

This command sets up parameters to use the Advanced Copy functions.
■
Syntax
set advanced-copy-parameters [-resolution {1|2|4|8|16}] [-table-size
[-ec-opc-priority {auto|very-low|low|middle|high|low}] [-warning
[-copy-schedule-mode {session-balancing|dst-rg-balancing}]
■ Parameter
-resolution
-table-size
-sdpe
Optional. This parameter specifies the Advanced Copy resolution. If omitted, the existing
setting is not changed.
1 (default)
1
2
2
4
4
8
8
16
16
Optional. This parameter specifies the Advanced Copy table size. The size can be specified in
multiples of 8MB. Note that the maximum value depends on the memory size that is to be
installed in the controllers. The initial value is set to 0MB. If omitted, the existing setting is not
changed.
The maximum Advanced Copy table size for each model are shown below:
ETERNUS DX80 S2/DX90 S2: 0 to 256MB
ETERNUS DX410 S2: 0 to 512MB
ETERNUS DX440 S2: 0 to 4096MB
ETERNUS DX8100 S2: 0 to 1024MB
ETERNUS DX8700 S2: 0 to 12288MB
Optional. This parameter specifies the resolution for the SDPV. The initial value is set to 1GB. If
omitted, the existing setting is not changed.
1g 1GB (default)
2g 2GB
4g 4GB
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
warning_level
391
table_size
] [-sdpe {1g|2g|4g}]
]
P2X0-1030-09ENZ0