Viewing Command Help; Error Message Format - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 1 Overview

1.6 Viewing Command Help

1.6 Viewing Command Help
By inputting a question mark (?) after the CLI command name or the parameter name, a brief description can
be displayed. By using the "help" command, the command syntax can also be displayed. For further
information, refer to the
# If a question mark [?] is entered by itself, the entire verb list is displayed.
CLI> ?
copy
create
delete
discover
exit
... (snip)
# If [s?] is entered, all the verbs beginning with "s" are displayed.
CLI> s?
set
# # If [show ?] is entered (note the space between the "show" and "?"), only the "show" command is
possible, so all the "show" command objects are displayed.
CLI> show ?
advanced-copy-licens - Display the Extended Advanced Copy license status.
advanced-copy-parame - Display the Advanced Copy parameters.
advanced-copy-policy - Display the currently registered Advance Copy policy.
advanced-copy-sessio - Display the list of Advance Copy sessions.
affinity-groups
group.
... (snip)
# If [show m?] is entered, all the "show" command objects beginning with "m" are displayed.
CLI> show m?
mapping
# If [create raid-group ?] is entered (note the space between the "create raid-group" and "?"), the
parameters that can be specified for the "create raid-group" command are displayed.
# Bracketed parameters are optional. All other parameters are required.
# Bracketed parameters are optional. All other parameters are required.
CLI> create raid-group ?
-name
-disks
-level
[-assigned-cm]
# Long parameters and command names are truncated at 20 characters, as in the following example.
# Note that one or more spaces are required before a question mark.
CLI> ?
[-host-response-num - Host response numbers to display details
[-host-response-nam - Host response names to display details
1.7

Error Message Format

This section explains the CLI error messages format. When the CLI command ends normally, there is no output
on the terminal and the CLI prompt is returned to the next line. If an error occurs, an error message is
"help" command.
- copy
- create
- delete
- discover
- Exit the CLI sessions.
show start
- Display a list of affinity groups or display the details of a specified affinity
migration
- Name of a RAID group
- Disks to use in the RAID group
- RAID level
- Assigned controller for the RAID group
29
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
stop
P2X0-1030-09ENZ0