Eco Schedule Syntax; Host Interface Port Syntax - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 1 Overview
1.2 The Command Syntax
• Host response name
A host response name must be specified when registering a host response. For details about the syntax,
refer to "1.2.4 Alias Name Syntax" (page
response names. A host response name and a host response number cannot both be specified in the same
command. Do not include spaces before or after commas.
Two or more parameters might not be able to be specified for several commands. For details, refer to the
command descriptions.
1.2.13

ECO Schedule Syntax

There are two methods to specify an ECO schedule identifier; an ECO schedule number or an ECO schedule
name.
• ECO schedule number
A schedule number is automatically created by the system when an ECO schedule is created. This is a
decimal number. ECO schedule numbers can be displayed by using the "show eco-schedule" command.
ECO schedule numbers may be combined as follows:
- A single ECO schedule number: 1
- A list of ECO schedule numbers: 2,5
- A hyphenated range of ECO schedule numbers from a to z: 2-5
- A list of ECO schedule numbers, ECO schedule ranges, or both, separated by commas. Spaces are not
permitted before or after commas: 1,3,10-12
• ECO schedule name
An ECO schedule name must be specified when creating an ECO schedule. For details about the syntax,
refer to "1.2.4 Alias Name Syntax" (page
schedule names. An ECO schedule name and an ECO schedule number cannot both be specified in the
same command. Do not include spaces before or after commas.
Two or more parameters might not be able to be specified for several commands. For details, refer to the
command descriptions.
1.2.14

Host Interface Port Syntax

A fixed 3-digit "xyz" numbering format is used. "x" indicates the controller module (CM) number, "y" indicates
the channel adapter (CA) number, and "z" indicates the host interface port number. For example, "110"
indicates CM#1-CA#1-Port#0. Two or more parameters can be specified by separating them with a comma. To
indicate both CM#0-CA#0-Port#0 and CM#1-CA#1-Port#0, specify "-port 000,110".
20). Some commands accept a comma-separated list of host
20). Some commands accept a comma-separated list of ECO
25
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0