Fujitsu ETERNUS DX80 S2 Cli User's Manual page 392

Chapter 4 Function/System Settings and Display
4.2 Advanced Copy Management > set advanced-copy-parameters
-ec-opc-priority
-warning
-copy-schedule-mode
■ Example(s)
The following example sets up Advanced Copy parameters. The resolution is set to twice the default, the
table size is set to 128MB, and the EC/OPC priority is set to automatic mode.
CLI> set advanced-copy-parameters -resolution 2 -table-size 128 -ec-opc-priority auto
Optional. This parameter specifies the EC/OPC priority and the EC/OPC rate mode. The initial
value is "auto". If omitted, the existing setting is not changed.
auto Automatically (default)
very-low Very low priority
low Low priority
middle Middle priority
high High priority
Optional. This parameter specifies the threshold value for Advanced Copy table usage. This
value is indicated by percent (%). The initial value is set to 80%. If omitted, the existing setting
is not changed. In addition, the system has a function that notifies users when this value
reaches the specified upper limit value. This upper limit value is set by using this parameter.
For details, refer to the "show event-notification" command.
Optional. This parameter specifies the Copy Schedule Mode. If omitted, the existing setting is
not changed.
session-balancing
Session balancing is performed.
dst-rg-balancing
Destination RAID Group balancing is performed.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
392
P2X0-1030-09ENZ0