Fujitsu ETERNUS DX80 S2 Cli User's Manual page 375

Chapter 4 Function/System Settings and Display
4.1 User Management > set radius
-secondary-port
-secondary-port-number
-secondary-authentication-mode
-secondary-shared-secret
-secondary-retry-timeout
■ Example(s)
The following example sets the RADIUS authentication server:
CLI> set radius -mode -after-error no -primary-server 10.21.134.198 -primary-port maintenance -primary-
port-number 1812 -primary-authentication-mode chap -primary-shared-secret "RADIUS Secret" -primary-retry-
timeout 20 -secondary-server 10.17.80.6 -secondary-port remote -secondary-port-number 1912 -secondary-
authentication-mode pap -secondary-shared-secret "RADIUS Secret1" -secondary-retry-timeout 20
Optional. This parameter specifies the LAN port for secondary settings. If omitted, the existing
setting is not changed.
maintenance
MNT port
remote RMT port
Optional. This parameter specifies the UDP port number of the secondary server for the
authentication protocol. Specify the port number within 1 to 5 digits. The port number cannot
be set above 65535. If omitted, the existing setting is not changed. The default value is 1812.
Optional. This parameter specifies the authentication method of the secondary server. CHAP or
PAP can be selected for the authentication method. If omitted, the existing setting is not
changed. The following methods can be specified.
chap Use CHAP. (Default)
pap Use PAP.
PAP: Password Authentication Protocol
Optional. This parameter specifies the shared secret of the secondary server. Up to 64
alphanumeric characters can be specified for the shared value. If omitted, the existing setting
is not changed.
Optional. This parameter specifies the retry timeout value of the secondary server. If omitted,
30 seconds (default value) is used. The timeout value should be selected from following
values:
10 10 seconds
20 20 seconds
30 30 seconds (Default value)
40 40 seconds
50 50 seconds
60 60 seconds
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
375
P2X0-1030-09ENZ0