Show Audit - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 4 Function/System Settings and Display
4.4 Miscellaneous > show audit

show audit

This command displays the settings of the audit log functions.
■
Syntax
show audit
■ Parameter
No parameters.
■ Output
# Audit Log
# Server1 function
# Server1
# Server1 Port Number
# Server1 Port
# Server2 function
# Server2
# Server2 Port Number
# Server2 Port
A: It indicates whether the audit log function is enabled.
B: It indicates whether syslog server 1 is enabled.
C: FQDN or IP address (IPv4 or IPv6) of the syslog server 1
D: UDP port number of the syslog server 1 for the syslog protocol
E: It indicates which port is used.
F: It indicates whether syslog server 2 is enabled.
G: FQDN or IP address (IPv4 or IPv6) of the syslog server 2
H: UDP port number of the syslog server 2 for the syslog protocol
I: It indicates which port is used.
■ Example(s)
The following example displays the settings of the audit log function:
CLI> show audit
Audit Log
Server1 Function
Server1
Server1 Port Number [514]
Server1 Port
Server2 Function
Server2
Server2 Port Number [517]
Server2 Port
Enable
A
Enable (RFC3164)
B
10.21.134.198
C
514
D
MNT
E
Enable (RFC5424)
F
10.17.80.6
G
517
H
RMT
I
[Enable]
[Enable (RFC3164)]
[10.21.134.198]
[MNT]
[Enable (RFC5424)]
[10.17.80.6]
[RMT]
586
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0