Set Ca-Reset-Group - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set ca-reset-group

set ca-reset-group

This command sets a reset group of host interface ports (Channel Adapter on controller module). The same
number of reset groups as the host interface ports that are installed in the storage system can be set as the
maximum. One reset group can be set at a time. In the initial state, all host interface ports are set in one reset
group.
■ Syntax
set ca-reset-group [-group
■
Parameter
-group
■ Example(s)
The following example sets up the reset groups. The reset groups are configured with CM#0 CA#0 Port#0 and
CM#0 CA#0 Port#1:
CLI> set ca-reset-group -group 000,001
xyz
]
This parameter sets up a combination of host interface ports that will be reset as a group. Two
or more host interface ports can be specified by separating them with a comma.
Example: -group 000,100
For details, refer to "1.2.14 Host Interface Port Syntax" (page
If a host interface port in the specified group is already set for another group, this port is
released from the group and reconfigured in the specified group.
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the host port
number.
Example: "123" indicates CM#1-CA#2-Host port#3
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
305
25).
P2X0-1030-09ENZ0