Show Led - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 5 Information Settings and Display
5.4 Utility > show led

show led

This command displays the status of the LEDs in each enclosure and each module.
■
Syntax
show led
■ Parameter
No parameters.
■ Output
# Controller Enclosure
# Panel
# Controller Module #0
# Controller Module #1
# Service Controller #0
# Service Controller #1
# DE#x-Disk #0 [ON] #1 [OFF] #2 [ON] #3 [ON] #4 [ON] #5 [-] #6 [-] #7 [-] #8 [-] #9 [-] #10[-] #11[-]
#12 [ON] #13[OFF] #14[ON] #15[ON] #16[-] #17[-] #18[-] #19[-] #20[-] #21[-] #22[-] #23[OFF]
F
A: LED status of the CE panel-unit
B: LED status of the CM#0 (This item is displayed only for the ETERNUS DX80 S2/DX90 S2 and ETERNUS DX410 S2/
DX440 S2)
C: LED status of the CM#1 (This item is displayed only for the ETERNUS DX80 S2/DX90 S2 and ETERNUS DX410 S2/
DX440 S2)
D: LED status of the SVC#0 (This item is displayed only for the ETERNUS DX8700 S2)
E: LED status of the SVC#1 (This item is displayed only for the ETERNUS DX8700 S2)
F: LED status of the DE#x-Disk#y
■ Example(s)
The following example displays the status of the LEDs of all components:
CLI> show led
Controller Enclosure
Panel
Controller Module #0
Controller Module #1
DE#00-Disk #0 [ON] #1 [ON] #2 [OFF] #3 [OFF] #4 [-] #5 [-] #6 [-] #7 [-] #8 [-] #9 [-] #10[-] #11[-]
DE#10-Disk #0 [ON] #1 [ON] #2 [ON] #3 [OFF] #4 [ON] #5 [-] #6 [-] #7 [-] #8 [-] #9 [-] #10[-] #11[-]
#12 [ON] #13[OFF] #14[ON] #15[ON] #16[-] #17[-] #18[-] #19[-] #20[-] #21[-] #22[-] #23[OFF]
[ON ]
A
[ON ]
B
[ON ]
C
[ON ]
D
[ON ]
E
[OFF]
[OFF]
[ON]
667
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0