Fujitsu ETERNUS DX80 S2 Cli User's Manual page 700

Appendix A Error Messages
Message
number
E5001
E5002
E5010
E5081
E5084
E5100
E5033
E5034
E5101
E5105
E5107
E5109
E5200
E5201
E5202
E5203
E5204
E5205
E5206
User authority to use the parameter is improper.
The specified parameter cannot be used with the current user privilege.
Authority of security is necessary for data decryption.
The data cannot be decrypted because the user does not have the required privilege.
The volume encryption is specified for SED disk.
Volume encryption cannot be performed for a RAID group that is configured with SEDs.
Abnormal pinned CBE error.
Formatting cannot be performed because Pin exists.
System not ready.
The status of the ETERNUS Disk storage system is "Not Ready".
No thin-provisioning license.
No Thin Provisioning license is registered.
Cannot Warm Boot CFL.
The warm boot cannot be performed because a concurrent firmware update is currently being performed
for a controller.
Cannot Hard Boot CFL.
The hard boot cannot be performed because a concurrent firmware update is currently being performed
for a controller.
Check thin-pro-pool Status.
The Thin Provisioning Pool cannot be formatted. Check the status of the Thin Provisioning Pool by using
the "show thin-pro-pools" command.
Not exist unused disk enough
The number of unused disks is insufficient.
RAID type is temporary.
The RAID group is temporarily being used.
RAID group belong to thin-provisioning-pool/flexible-tier-pool
The RAID group belongs to a Thin Provisioning Pool or a Flexible Tier Pool.
No copy license.
No copy license is registered.
Invalid copy phase
The current phase of the copy session is incorrect. Check the session phase by using the "show advanced-
copy-sessions" command.
Exist SDV / SDPV.
SDVs or SDPVs exist.
Exist REC disk buffer.
REC disk buffer volumes exist.
Exist REC buffer.
The REC buffer is set.
Exist REC path setting.
The REC path is set.
Exist any of copy session(s).
Copy sessions exist. Check the sessions by using the "show advanced-copy-sessions" command. Wait until
the copy sessions finish, and then try again.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
Message
Countermeasure for the error
700
P2X0-1030-09ENZ0