Set Storage-System-Name - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Disk storage systems
Hide thumbs Also See for ETERNUS DX80 S2:
Table of Contents

Advertisement

Chapter 4 Function/System Settings and Display
4.4 Miscellaneous > set storage-system-name

set storage-system-name

This command sets the ETERNUS DX Disk storage system information. Note that the Virtual Disk Service (VDS)
"Friendly" name corresponds to the ETERNUS DX Disk storage system name.
Syntax
set storage-system-name [-name
[-contact
contact
Parameter
-name
-installation-site
-contact
-description Optional. This parameter specifies the description of the ETERNUS DX Disk storage system (up
Example(s)
The following example sets the ETERNUS DX Disk storage system name, installation site name, descriptions,
and contact address:
CLI> set storage-system-name -name E2000-No1 -installation-site FJ -contact AVRIL -description CALC2
name
] [-installation-site
] [-description
description
Optional. This parameter specifies the ETERNUS DX Disk storage system name (up to 16
characters). Permitted characters are described in
If omitted, the existing setting is not changed.
Optional. This parameter specifies the installation site name (up to 50 letters). Permitted
characters are described in
existing setting is not changed.
Optional. This parameter specifies the administrator address (up to 50 characters). Permitted
characters are described in
existing setting is not changed.
to 50 characters). Permitted characters are described in
(page
19). If omitted, the existing setting is not changed.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
location
]
"1.2.2 Keywords and Parameters" (page
"1.2.2 Keywords and Parameters" (page
"1.2.2 Keywords and Parameters" (page
562
]
19). If omitted, the
19). If omitted, the
"1.2.2 Keywords and Parameters"
P2X0-1030-09ENZ0
19).

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents