Ftrpe Migration - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.2 Flexible Tier Management
3.2.2

FTRPE Migration

This section explains the commands used for FTRPE (Flexible Tier Pool Element) Migration management.
• Checking the FTRPE Migration status
■ Summary of FTRPE Migration settings through CLI
The steps involved in settings the FTRPE Migration using CLI are as follows:
Procedure
1
FTRPE Migration
Use the "show ftrpe-migration" command to check the status of FTRPE Migration.
Only user accounts with the Software Control policy can execute FTRPE Migration and check the status
of FTRPE Migration. User accounts without the Software Control policy cannot use the FTRPE Migration
function.
FTRPE Migration uses the same session table that is used by RAID Migration, Flexible Tier Migration,
and Thin Provisioning Volume balancing. Since up to only 32 sessions can be registered in this session
table and the ETERNUS DX Disk storage system can have up to 512 FTRPE Migration sessions, other
Migration sessions are in a state of waiting for registration while FTRPE Migration is being executed.
104
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
End of procedure
P2X0-1030-09ENZ0