Eco Management - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.3 RAID Group Management
3.3.3

ECO Management

This section explains the commands that are related to the ECO functions. They are only applicable when the
ECO mode is enabled using the "set eco-mode" command.
The three steps involved in enabling the ECO functions are as follows:
Procedure
1
Enable the ECO mode.
2
Create an ECO schedule.
3
Assign the ECO schedule to RAID groups.
128
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
End of procedure
P2X0-1030-09ENZ0