Show Sas-Parameters - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show sas-parameters

show sas-parameters

This command displays the parameters of each SAS host interface port.
■
Syntax
show sas-parameters
■ Parameter
No parameters.
■ Output
# Port
-> Each host interface port number
# Host Affinity
-> Host affinity mode of each host interface port
# Transfer Rate
-> SAS Transfer rate (Auto Negotiation / 1.5Gbit/s / 3Gbit/s / 6Gbit/s)
# Host Response No.
# Host Response Name
-> Host response number (The hyphen is shown when the host affinity mode is enabled.)
# Reset Scope
-> Range of reset action I_T_L (I: Initiator, T: Target, L:LUN) or T_L (T: Target, L: LUN)
# Reserve Cancel at Chip Reset
-> It shows whether reservations are canceled or not when a host interface port is reset.
CM#0 CA#0 Port#0 CM#0 CA#0 Port#1
Disable Enable
3Gbit/s 3Gbit/s
5 6
HP05 HP06
I_T_L I_T_L
Disable Enable
206
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0