Chapter 3 Configuration Settings and Display
3.3 RAID Group Management > set global-spare
set global-spare
This command assigns a disk as a Global Hot Spare. A Global Hot Spare is used as a substitute for a disk that
has failed in a RAID group. A Global Hot Spare is shared by all of the existing RAID groups (except for RAID0
level). A list of registered hot spare disks can be displayed by using the "show disks" command.
■
Syntax
set global-spare -disks
■
Parameter
-disks
■
Example(s)
The following example registers disks #101 and #102 as Global Hot Spares:
CLI> set global-spare -disks 101,102
In the following example, disks #101 and #102 are assigned as Global Hot Spares and disk #103 is then
added to the available Global Hot Spare pool. Adding additional Global Hot Spares does not remove any hot
spares that are previously set:
CLI> set global-spare -disks 101,102
CLI> set global-spare -disks 103
disks
This parameter specifies the disks to be registered as Global Hot Spares. One or more disks can
be specified. For details, refer to
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
"1.2.3 Disk Syntax" (page
124
19).
P2X0-1030-09ENZ0