Fujitsu ETERNUS DX80 S2 Cli User's Manual page 244

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-iscsi-name
-ip
-name
-chap-user
-host-response-number
or
-host-response-name
-cmdsn-count
■ Example(s)
The following example changes the host named "HBA21", assigning it the new IP address "10.1.1.2" (the IP
address format can also be changed to a different format, such as from IPv4 to IPv6):
CLI> set host-iscsi-name -host-name HBA21 -ip 10.1.1.2
Optional. This parameter specifies the IP address for the HBA using IPv4 standard notation (a
base 256 "d.d.d.d" string) or IPv6 format. This parameter can also change the IP address format
to a different format, such as from IPv4 to IPv6. The types of IPv6 addresses that can be speci-
fied are global addresses (including 6to4 addresses), link local addresses, and unique local
addresses. Only one IP address can be specified at any given time. If omitted, the existing
setting is not changed.
Example: -ip 192.168.1.10
Example: -ip fe80::223:4567:89ab:cdef
When changing the access from a specific IP address to any IP address, delete relevant host
name using the "delete host-iscsi-name" command, and then create the same host name
again using the "create host-iscsi-name" command (without specifying the "-ip" parameter).
Optional. This parameter specifies the new iSCSI-host alias. For details, refer to
Name Syntax" (page 20). If omitted, the existing setting is not changed. Only one name can
be specified at the same time.
Optional. When using CHAP authentication, this parameter is used to specify a CHAP user
name. Up to 255 alphanumerical characters and some symbols can be used. If this parameter
is specified, then the command displays a CHAP user password prompt. To delete an existing
CHAP user name, specify the operand as "" (two consecutive double quotations with no
intervening space). If omitted, the existing setting is not changed. Only one user can be
specified at any given time.
Optional. This parameter specifies the host response identifier. One or more identifiers can be
specified at the same time. For details, refer to
omitted, the existing setting is not changed.
Optional. This parameter specifies the number of commands that can be accepted at the same
time.
unlimited Unlimited
20 20 commands
40 40 commands
80 80 commands
120 120 commands
180 180 commands
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
"1.2.12 Host Response Syntax" (page
244
"1.2.4 Alias
24). If
P2X0-1030-09ENZ0