Show Host-Path-State - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-path-state

show host-path-state

This command displays the path status (access availability status from the target host) that is defined in the
mapping of the associated host interface ports that are set.
■ Syntax
show host-path-state [-port {
■ Parameter
-port
■ Output
# Port
#
# CM#0 CA#0 Port#0
# CM#0 CA#0 Port#0
# CM#0 CA#0 Port#1
# CM#0 CA#0 Port#1
A
A: Port number
B: Host number
C: Host name
D: Access availability status from the target host
■ Example(s)
The following example displays the status of all of the paths for all of the associated host interface ports:
CLI> show host-path-state
Port
CM#0 CA#0 Port#0
CM#0 CA#0 Port#0
CM#1 CA#0 Port#1
CM#1 CA#0 Port#1
xyz
|all}
Optional. This parameter specifies the host interface port that is to be displayed. Multiple
parameters can be set by separating each one by a comma. If omitted, the process is
performed as if all of the host interface ports are selected.
Example: -port 000,100
For details, refer to "1.2.14 Host Interface Port Syntax" (page
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the host
port number.
Example: 123 (host port#3 of CA#2 on CM#1)
all All of the host interface ports (default)
Host
No. Name
0 FC#0
1 FC#1
0 FC#0
1 FC#1
B C
Host
No. Name
0 FC#0
1 FC#1
0 FC#0
1 FC#1
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
Path State
Online
Online
Online
Offline
D
Path State
Online
Online
Online
Offline
270
25).
P2X0-1030-09ENZ0