Fujitsu ETERNUS DX80 S2 Cli User's Manual page 212

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set iscsi-parameters
-isns-server Optional. This parameter specifies whether or not an iSNS server is used. If omitted, the
-isns-server-port
-chap
-chap-user
-header-digest
-data-digest
-jumbo-frame
existing setting is not changed.
enable An iSNS server is used.
disable An iSNS server is not used.
Optional. This parameter specifies iSNS server port number. The default iSNS server port
number value is 3205. This parameter cannot be specified when the port is set to the RA mode.
0 – 65535 iSNS server port number
Optional. This parameter specifies whether or not CHAP authentication is used. If omitted, the
existing setting is not changed.
enable A CHAP authentication is used.
disable A CHAP authentication is not used.
Optional. This parameter specifies the user name for CHAP authentication. It is only applicable
if CHAP authentication is used. Up to 255 alphanumerical characters and symbols for CA ports
and up to 63 alphanumerical characters and symbols for RA ports can be used. If this
parameter is specified, then the command displays a CHAP user password prompt. If omitted,
the existing setting is not changed. To delete a currently registered CHAP user name, specify
consecutive double quotations (-chap-user "") without any spaces.
Optional. This parameter specifies whether or not the PDU header's CRC32C checksum is
validated. The initial value is set to disabled. Specify "disable" for the "-header-digest"
parameter to disable the Digest function. When "enable" is specified for the "-header-digest"
parameter, data transfer may fail. If omitted, the existing setting is not changed. This
parameter cannot be specified when the port is set to the RA mode.
enable PDU header is validated by CRC32C.
disable PDU header is not validated.
Optional. This parameter specifies whether or not the PDU data's CRC32C checksum is
validated. The initial value is set to disabled. Specify "disable" for the "-data-digest" parameter
to disable the Digest function. When "enable" is specified for the "-data-digest" parameter,
data transfer may fail. If omitted, the existing setting is not changed. This parameter cannot
be specified when the port is set to the RA mode.
enable PDU data is validated by CRC32C.
disable PDU data is not validated.
Optional. This parameter specifies whether or not jumbo frame can be specified. If omitted,
the existing setting is not changed. The initial value is set to disabled. This parameter cannot
be specified when the port is in RA mode or CA/RA auto mode.
enable The jumbo frame is accepted.
disable The jumbo frame is not accepted.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
212
P2X0-1030-09ENZ0