Fujitsu ETERNUS DX80 S2 Cli User's Manual page 298

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-response
■ Example(s)
The following example displays the details of host response #5:
CLI> show host-response -host-response-number 5
Host Response No.5
Host Response Name
Byte-0 of Inquiry Response
Inquiry VPD ID Type
Inquiry Standard Data Version
Command Timeout Interval
Load Balance Response
Reservation Conflict Response for Test Unit Ready
Change Volume Mapping
Volume Capacity Expansion
Vendor Unique Sense Code
Host Specific Mode
Asymmetric / Symmetric Logical Unit Access
iSCSI Discovery Reply Mode
TPGS Mode
TPG Referrals
iSCSI Reservation Range
The following example lists a summary of all the existing host responses:
CLI> show host-response
Host Response
No. Name
1 am0001000111
2 am0002
3 am0003
am0005
Not conversion (Default)
Type1 + Type3 (Default)
Version 5 (Default)
25 (Default)
Unit Attention (Default)
Normal (Default)
Not report (Default)
Not report (Default)
Not report (Default)
Normal (Default)
ACTIVE-ACTIVE / PREFERRED_PATH
Reply target port only
Enable (Default)
Disable (Default)
Port (Default)
298
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0