Set Snmp-User - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 4 Function/System Settings and Display
4.3 Network Management > set snmp-user

set snmp-user

This command modifies SNMP user settings.
■
Syntax
set snmp-user {-user
[-authentication {enable | disable}] [-authentication-method {md5 | sha}]
[-encryption {enable | disable}]
■ Parameter
-user
or
-number
-view
-authentication
-authentication-method
-encryption Optional. This parameter specifies the encryption mode. If this parameter is set to enable, the
■
Example(s)
The following example sets user FooVar to SNMP view "xview4":
CLI> set snmp-user -user FooVar -view xview4
user_name
| -number
This parameter specifies the SNMP user name or user number.
The user number can be confirmed by using the command "show snmp-user".
This parameter specifies the name of the MIB view that will be changed. Only one view can be
specified at the same time. Up to 32 characters can be specified for a view name. If double
quotation marks ("") are specified, the associated view is removed from this user setting.
Optional. This parameter specifies whether to enable authentication. If it is specified, the
"-authentication-method" and "-encryption" options can be specified. In addition, the ETERNUS
DX Disk storage system confirms the authentication password. Between 8 and 64 characters
can be used for the password.
If omitted, the existing setting is not changed.
enable Authentication is enabled.
disable Authentication is disabled.
Optional. This parameter specifies which authentication method is used. One of the following
methods can be selected. If omitted, the existing setting is not changed.
md5 MD5 (default)
sha SHA
ETERNUS DX Disk storage system confirms the encryption password. Between 8 and 64
characters can be used for the password. If omitted, the existing setting is not changed.
enable Encryption is enabled.
disable Encryption is disabled.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
number mib_view_name
} -view {
485
|""}
P2X0-1030-09ENZ0