Show Volume-Mapping - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.4 Volume Management > show volume-mapping

show volume-mapping

This command displays the LUNs (Logical Unit Numbers) that are mapped to volumes.
■
Syntax
show volume-mapping
[-volume-number
■ Parameter
-volume-number
or
-volume-name
-mode
■ Output
#Volume
#No. Name
# 0 OLU#0
# A B
#<Mapping>
# LUN Affinity/LUN Group
# No.
# 0
# E F
#<Host LUN>
# LUN Port
#
# 0 CM#0 CA#0 Port#0
# E H
volume_numbers
| -volume-name
Optional. This parameter specifies the volume identifiers. One or more parameters can be
specified at the same time. If the volume identifier is omitted, the progress status of all the
volumes is displayed. For details, refer to
Optional. This parameter toggles the extended output mode. If the mode is omitted,
"default" is set.
all In addition to the normal display items, the information of the LUNs that
can be accessed from the host of each connected CA port is also displayed.
host-lun Only the information of the LUNs that can be accessed from the host of
each connected CA port is displayed.
default A list of all of the volumes is displayed.
Type UID
Standard 600000000100000002A2AAA00000000
C D
Port
Name
0 LG#0 -
G H
Host
No. Name
0 FC#0
I J
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
volume_names
] [-mode {all| host-lun | default}]
"1.2.9 Volume Syntax" (page
Affinity/LUN Group
No. Name
0 LG#0
F G
160
22).
P2X0-1030-09ENZ0