Set Snmp - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 4 Function/System Settings and Display
4.3 Network Management > set snmp

set snmp

This command enables or disables SNMP and specifies the port to be used for SNMP.
■
Syntax
set snmp [-function {enable|disable}] [-port {maintenance|remote}]
[-authentication-failure {enable|disable}] [-engine-id {
[-mib-ii-rfc-version {1213|4293}]
■ Parameter
-function
-port
-authentication-failure
-engine-id
-mib-ii-rfc-version
Optional. This parameter specifies whether SNMP functions are enabled or not. The initial
value is disabled. If omitted, the existing setting is not changed.
enable Functions of each SNMP are enabled.
disable Functions of each SNMP are disabled (default).
Optional. This parameter specifies the SNMP trap sending port. This parameter is only applied
when the trap version is V1 and affects all traps. If omitted, the existing setting is not changed.
The default is the MNT port.
maintenance
MNT port (default)
remote RMT port
Optional. This parameter specifies if the SNMP authentication failure function is enabled. This
function is used to notify the operator of Authentication Failure by an SNMP trap when this
system is accessed from a undefined SNMP community. If omitted, the existing setting is not
changed. The initial value is enabled.
enable An SNMP trap is notified when SNMP authentication fails (default).
disable An SNMP trap is not notified when SNMP authentication fails.
Optional. This parameter specified the engine identifier. The engine identifier is 12 to 66
characters because of 5 to 32bytes hexadecimal value which followed from the "0x". It is not
available which set all of character is "00" and/or "ff". When "default" is specified, the default
value is used.
If omitted, the existing id or default value is used.
Optional. This parameter specifies the version of MIB-II that is used by the ETERNUS DX Disk
storage system. If omitted, the existing setting is not changed.
1213 The RFC1213 format is used. (default)
4293 The RFC4293 format is used.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
engine_id
|default}]
469
P2X0-1030-09ENZ0