Chapter 4 Function/System Settings and Display
4.2 Advanced Copy Management > start advanced-copy
start advanced-copy
This command starts an Advanced Copy SnapOPC+ session. All other Copy types cannot be started using this
command.
■
Syntax
start advanced-copy
{-source-volume-number
{-destination-volume-number
■
Parameter
-source-volume-number
or
-source-volume-name
-destination-volume-number
or
-destination-volume-name
■
Example(s)
The following example starts an Advanced Copy session from the volume named "OPEN1" to the volume
named "SDV1":
CLI> start advanced-copy -source-volume-name OPEN1 -destination-volume-name SDV1
volume_number
sdv_number
This parameter specifies the volume identifier of the copy source. The type must be OPEN.
Only one volume can be specified at the same time. For details, refer to
(page
22).
This parameter specifies the volume identifier of copy destination. The type must be SDV. Only
one volume can be specified at the same time. For details, refer to
(page
22).
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
| -source-volume-name
volume_name
| -destination-volume-name
399
}
sdv_name
}
"1.2.9 Volume Syntax"
"1.2.9 Volume Syntax"
P2X0-1030-09ENZ0