Show Volumes - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.4 Volume Management > show volumes

show volumes

This command lists details of all the existing volumes or specified volumes.
This command is also used to display the details of Flexible Tier Volumes (FTVs).
Encryption-related functions may not be available for some user environments.
■
Syntax
show volumes [{-rg-number
{-pool-number
{-ftrp-number
-type {standard|sdv|sdpv|tpv|ftv|wsv} | -mode {expansion|uid|wsv|ftv|default}]
■ Parameter
-rg-number
or
-rg-name
-pool-number
or
-pool-name
rg_number
pool_number
| -pool-name
ftrp_number | -ftrp-name
Optional. This parameter specifies RAID group identifiers. The details of the volumes in a RAID
group will be displayed. If the RAID group identifier is omitted, a summary of all the volumes
that exist in the system is displayed. For details, refer to
• Only one parameter can be specified.
• Other parameters (except for "-mode default") cannot be specified at the same time.
Optional. This parameter specifies the Thin provisioning pool identifier. The details of the
volumes on a Thin provisioning pool will be displayed. If omitted, a summary of all the
volumes that exist in the system is displayed. For details, refer to
Syntax" (page 20).
• Only one parameter can be specified.
• Other parameters (except for "-mode default") cannot be specified at the same time.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
rg_name
| -rg-name } |
pool_name
} |
ftrp_name } |
153
"1.2.8 RAID Group Syntax" (page
"1.2.5 Thin Provisioning Pool
P2X0-1030-09ENZ0
22).