Set Smi-S - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 4 Function/System Settings and Display
4.3 Network Management > set smi-s

set smi-s

This command enables or disables the SMI-S functions.
■
Syntax
set smi-s [-function {enable | disable}]
■ Parameter
-function
■ Example(s)
The following example disables all the SMI-S functions:
CLI> set smi-s -function disable
Optional. This parameter specifies whether all SMI-S functions are enabled or not. The initial
value is disabled. If omitted, the existing setting is not changed. To enable this parameter,
power cycle the system is required.
enable Each SMI-S function is enabled.
disable Each SMI-S function is disabled (default).
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
528
P2X0-1030-09ENZ0