Copy Mapping - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > copy mapping

copy mapping

This command copies the mapping definition from one specified host interface port to others. This command
cannot be used when Host Affinity Mode for the host interface port is enabled.
■ Syntax
copy mapping -source-port {
■ Parameter
-source-port This parameter specifies the host interface port of the copy source. Only one parameter can be
-destination-port
■
Example(s)
The following example copies the mapping definition from host interface port #0 on CM#0 CA#0 to host
interface port #0 on CM#1 CA#0:
CLI> copy mapping -source-port 000 -destination-port 100
The following example copies the mapping definition from host interface port #0 on CM#0 CA#0 to host
interface ports #0 and #1 on CM#1 CA#1:
CLI> copy mapping -source-port 000 -destination-port 110,111
xyz
} -destination-port {
specified at the same time.
Example: -source-port 000
For details, refer to "1.2.14 Host Interface Port Syntax" (page
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the host port
number.
Example: "123" indicates CM#1-CA#2-Host port#3
This parameter specifies the host interface ports to be released. Two or more parameters can
be specified by separating them with a comma.
Example: -destination-port 000,100
For details, refer to "1.2.14 Host Interface Port Syntax" (page
If "all" is selected, all of the host interface ports will be changed.
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the host port
number.
Example: "123" indicates CM#1-CA#2-Host port#3
all All the host interface ports
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
xyz
|all}
286
25).
25).
P2X0-1030-09ENZ0