Set Iscsi-Parameters - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set iscsi-parameters

set iscsi-parameters

This command sets up the parameters of each iSCSI host interface port. It can also be used to change Host
Affinity Mode.
■ Syntax
set iscsi-parameters -port {xyz | all}
[-host-affinity {enable | disable}]
[-iscsi-name
[-alias-name
[-host-response-number
[-reset-scope {initiator-lun | target-lun}] [-reserve-cancel {enable | disable}]
[-ipv4-flag {enable | disable}] [-ip
[-ipv6-flag {enable | disable}] [-link-local-ip
[-ipv6-gateway {
tcp_port_number
[-tcp-port
[-congestion-control-option {enable | disable}]
[-isns-server-ip
[-isns-server-port
[-chap {enable | disable}] [-chap-user
[-header-digest {enable | disable}] [-data-digest {enable | disable}]
[-jumbo-frame {enable|disable}]
[-rate {auto|1gauto|10gauto|1gfull|100mfull}] [-cmdsn-count {unlimited|20|40|80|120|180}]
[-vlan-id {enable | disable}] [-vlan-id-value {0 - 4095}]
mtu_size
[-mtu
[-bandwidth
[-chap-ca {enable | disable}]
[-chap-user-ca
[-chap-ra {enable | disable}]
[-chap-user-ra
[-rec-line-no
[-rec-transfer-sync {enable|disable}] [-rec-transfer-stack {enable|disable}]
[-rec-transfer-consistency {enable|disable}] [-rec-transfer-through {enable|disable}]
■ Parameter
-port
iscsi_name
]
alias_name
]
host_response_number
ip_address
gateway
| auto}]
] [-tcp-window-scale
isns_server_ip
] [-isns-server {enable | disable}]
isns_server_port_number
chap_user_name
]
bandwidth_limit ]
chap_user_name-ca
]
chap_user_name-ra
]
rec-line-no
]
This parameter specifies which iSCSI interface port is to be set. Multiple comma-separated
ports may be specified.
Example: -port 000,110
For details, refer to "1.2.14 Host Interface Port Syntax" (page
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the iSCSI port
number.
Example: 110 (CM#1, CA#1, iSCSI port#0)
all All iSCSI interface ports
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
| -host-response-name
netmask
] [-netmask ] [-gateway
ip_address ] [-connect-ip {
tcp_window_scale
]
]
]
208
host_response_name
]
gateway
]
ip_address | auto}]
25).
P2X0-1030-09ENZ0