Set Affinity-Group - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set affinity-group

set affinity-group

This command changes an existing affinity group and can also be used to add a definition to the affinity
group.
■ Syntax
set affinity-group {-ag-number
[{-volume-number
■ Parameter
-ag-number
or
-ag-name
-name
-volume-number
or
-volume-name
-lun
source_ag_number
volume_numbers | -volume-name
This parameter specifies the affinity group identifier to be changed. Only one affinity group
can be specified at the same time. For details, refer to
Optional. This parameter specifies the new affinity group name. Only one name can be
specified at the same time. If omitted, the existing setting is not changed.
Optional. This parameter specifies the volume identifiers to add a definition to the specified
affinity group, and is paired with the "-lun" parameter. One or more parameters can be
specified at the same time. If omitted, the existing setting is not changed. For details, refer to
"1.2.9 Volume Syntax" (page
also be specified in the same order as the associated volumes. Any already assigned
definitions cannot be specified.
Example:
-volume-number 10-12 -lun 1-3
-> The volume #10 and LUN 1 are pairs.
-> The volume #11 and LUN 2 are pairs.
-> The volume #12 and LUN 3 are pairs.
-volume-name v1,v2 -lun 1-2
-> The volume named "v1" and LUN 1 are pairs.
-> The volume named "v2" and LUN 2 are pairs.
Optional. This parameter specifies LUNs to add a definition to the specified affinity group, and
is paired with volume identifiers. If omitted, the existing setting is not changed. If two or more
volume identifiers are specified, these parameters must be specified in the same order as the
associated LUNs. Any already assigned definitions cannot be specified.
Two or more parameters can be specified by separating them with a comma, a hyphen, or
both.
Example: -lun 0,1 -lun 0-10 -lun 1,6-8
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
source_ag_name
| -ag-name
volume_names
"1.2.11 Affinity Group Syntax" (page
22). If two or more LUNs are specified, these parameters must
254
name
} [-name ]
} {-lun luns }]
P2X0-1030-09ENZ0
24).