Show Events - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 5 Information Settings and Display
5.2 Event Log Information > show events

show events

This command displays event information which has occurred in the system. The events displayed can be
narrowed down by specifying various parameters. If all the parameters are omitted, all events are displayed. If
multiple parameters are specified, the events displayed function according to the parameters that are set.
■ Syntax
show events [ -severity { information | warning | error } ] [ -cm {0|1|2|3|4|5|6|7} ] [ -count count ]
■ Parameter
-severity
-cm
-count
■ Output
# 2008-01-01 12:00:05
A
A: The date and time which the events have occurred
B: Event severity
C: Abbreviation of event type
(T: Test I: Information J/W: Warning P/E: Error M: Maintenance R: Recovery)
D: Event code (fixed eight-digit)
E: Event message
Optional. This parameter specifies the severity of the event level. When severity is specified,
the display is restricted to information about events of the specified severity level. Only one
level can be specified at the same time. If omitted, all the events of the severity levels are
displayed.
information Information level
warning Warning level
error Error level
Optional. This parameter specifies the controller module number. Only events for the specified
CM are displayed. If omitted, all the events of all CMs are displayed.
0 CM#0
1 CM#1
2 CM#2
3 CM#3
4 CM#4
5 CM#5
6 CM#6
7 CM#7
Optional. This parameter limits how many events are displayed, selecting from the latest event
and working backward. If omitted, all the events are displayed.
Error
B
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
P 01000000 Controller module #0 Fault
C D E
624
P2X0-1030-09ENZ0