Fujitsu ETERNUS DX80 S2 Cli User's Manual page 197

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set fc-parameters
-rate
-loop-id-assign
-loop-id
-frame-size Optional. This parameter specifies the FC frame size. If omitted, the existing setting is not
-host-response-number
or
-host-response-name
loop Loop connection (default)
fabric Fabric connection
Optional. This parameter specifies the FC transfer rate. If omitted, the existing setting is not
changed.
auto Auto negotiation
1g 1Gbit/s (Not supported)
2g 2Gbit/s
4g 4Gbit/s
8g 8Gbit/s
16g 16Gbit/s
Specify "auto", "2g", "4g", "8g", or "16g" for the transfer rate. Note that "1g" is not supported.
Optional. This parameter specifies how to assign the loop ID. It is only applicable when
"-connect loop" is specified. If omitted, the existing setting is not changed.
auto-ascending
It automatically assigns ascending order.
auto-descending
It automatically assigns descending order.
manual It assigns manually.
Optional. This parameter specifies the loop ID (a hexadecimal number). This is only applicable
when "-loop-id-assign manual" is specified. The range of values is between 0x00 and 0x7d (a
hexadecimal number). If omitted, the existing setting is not changed.
changed. If the RA mode or Initiator mode is being set for the specified ports, this parameter
cannot be specified.
512 512 byte.
1024 1024 byte.
2048 2048 byte.
Optional. This parameter specifies a host response identifier. Only one host response identifier
can be specified at the same time. If omitted, the existing setting is not changed. If the RA
mode or Initiator mode is being set for the specified ports, this parameter cannot be specified.
For details, refer to "1.2.12 Host Response Syntax" (page
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
24).
197
P2X0-1030-09ENZ0