Show Fcoe-Parameters - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show fcoe-parameters

show fcoe-parameters

This command displays the parameters of each FCoE host interface port.
■
Syntax
show fcoe-parameters
■ Parameter
No parameters.
■ Output
# Port
-> Each host interface port number
# Port Mode
-> Each port mode (CA)
# Transfer Rate
-> FC transfer rate (10Gbit/s)
# Frame Size
-> FC frame size (512/1024/2048 byte)
# Host Affinity
-> Host affinity mode of each host interface port
# Host Response No.
# Host Response Name
-> Host response number (The hyphen is shown when the host affinity mode is enabled.)
# Reset Scope
-> Range of reset action I_T_L (I: Initiator, T: Target, L: LUN) or T_L (T: Target, L: LUN)
# Reserve Cancel at Chip Reset
# FCF VLAN ID
-> FCF VLAN ID Enable/Disable and setting value.
#FCF Fabric Name
-> FCF Fabric Name Enable/Disable and setting value.
CM#0 CA#0 Port#0 CM#0 CA#0 Port#1
CA CA
10Gbit/s 10Gbit/s
2048bytes 512bytes
Disable Enable
5 6
HP05 HP06
I_T_L I_T_L
Disable Enable
Disable Enable
55
Disable Enable
0001000100010001
223
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
CM#0 CA#0 Port#2 CM#0 CA#0 Port#3
CA CA
10Gbit/s 10Gbit/s
2048bytes 2048bytes
Disable Enable
7 8
HP07 HP08
I_T_L I_T_L
Disable Enable
Disable Enable
100
Disable Enable
0002000200020002
P2X0-1030-09ENZ0