Transform-Set - Dell Z9500 Reference Manual

Dell#

transform-set

Specify the transform set the crypto policy uses.
Z9500
Syntax
transform-set transform-set-name
To delete a transform set from the crypto policy, use the no transform-set
transform-set-name command.
Parameters
transform-set-
name
Defaults none
Command CONFIG-CRYPTO-POLICY
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
9.2(0.0)
Internet Protocol Security (IPSec)
Destination address
Destination mask
Destination port
source-interface name :
source-interface num
Match sequence Num
Protocol type
IP or IPv6
Source address
Source mask
Source port
Destination address
Destination mask
Destination port
source-interface name :
source-interface num
Enter the name for the crypto policy transform set.
Descrption
Introduced on the Z9500.
Introduced on the Z9000, S4810, and S4820T.
: a::2
: /128
: 21
:
: 3
: tcp
: IPv6
: a::1
: /128
: 21
: a::2
: /128
: 0
:
891