Dell Z9500 Reference Manual page 207

Parameters
access-list-
name
in
out
implicit-permit
vlan vlan-id
Defaults Not enabled.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
7.6.1.0
7.5.1.0
6.2.1.1
Usage You can assign one ACL (standard or extended ACL) to an interface.
Information
When you apply an ACL that filters IGMP traffic, all IGMP traffic is redirected to the
CPUs and soft-forwarded, if necessary, in the following scenarios:
•
Access Control Lists (ACL)
Enter the name of a configured access list, up to 140
characters.
Enter the keyword in to apply the ACL to incoming traffic.
Enter the keyword out to apply the ACL to outgoing traffic.
(OPTIONAL) Enter the keyword implicit-permit to
change the default action of the ACL from implicit-deny to
implicit-permit (that is, if the traffic does not match the filters
in the ACL, the traffic is permitted instead of dropped).
(OPTIONAL) Enter the keyword vlan then the ID numbers of
the VLANs. The range is from 1 to 4094 (you can use IDs
from 1 to 4094).
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
NOTE: This command supports Loopback interfaces EE3 and EF series route
processor modules (RPMs). This command does not support Loopback
interfaces ED series RPMs, C-Series or S-Series Loopback interfaces.
on a Layer 2 interface — if a Layer 3 ACL is applied to the interface
207