Set Local-Preference - Dell Z9500 Reference Manual

level-1-2
level-2
stub-area
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Related
set automatic-tag
Commands
set metric
set metric-type
set tag

set local-preference

To set the BGP LOCAL_PREF attribute for routers within the local autonomous system, configure a filter.
Z9500
Syntax
set local-preference value
To delete a BGP LOCAL_PREF attribute, use the no set local-preference
command.
310
Enter the keyword level-1-2 to redistribute matched
routes to IS-IS Level 1 and Level 2.
Enter the keyword level-2 to redistribute matched routes
to IS-IS Level 2.
Enter the keyword stub to redistributed matched routes to
OSPF stub areas.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— computes the tag value of the route.
— specifies the metric value assigned to redistributed routes.
— specifies the metric type assigned to redistributed routes.
— specifies the tag assigned to redistributed routes.
Access Control Lists (ACL)