Dell Z9500 Reference Manual page 372

out
A.B.C.D
X:X:X:X::X
dampening
events
ipv4
ipv6
keepalives
notifications
soft-
reconfiguration
updates
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Usage
To view information on both incoming and outgoing routes, do not include the in
Information
and out parameters in the debugging command. The in and out parameters
cancel each other; for example, if you enter the debug ip bgp in command and
then enter the debug ip bgp out command, you do not see information on the
incoming routes.
Entering a no debug ip bgp command removes all configured debug
commands for BGP.
372
(OPTIONAL) Enter the keyword out to view only information
on outbound BGP routes.
Enter the IP address of peer in the A.B.C.D format.
Enter the IPv6 IP address of peer in the X:X:X:X::X format.
Enter the keyword dampening to view BGP dampening.
Enter the keyword events to view BGP protocol events.
Enter the ipv4 IP address to view the IPV4 route information.
Enter the ipv6 IP address to view the IPV6 route information.
Enter the keyword keepalives to view BGP keepalives.
Enter the keyword notifications to view BGP
notifications.
Enter the keywords soft-reconfiguration to view only
information on inbound BGP soft reconfiguration.
Enter the keyword updates to view BGP updates.
Introduced on the S6000–ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Border Gateway Protocol