Dell Z9500 Reference Manual page 999

Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
9.0.0.0
8.3.19.0
8.3.7.1
8.4.2.1
Usage
Information
Example
Dell# show ipv6 interface linecard 0
TenGigabitEthernet 0/2 is down, line protocol is down
IPv6 Basics
EXEC
EXEC Privilege
Description
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series.
NOTE: If a route has a mask greater than 64, no output is displayed but an
equivalent /64 entry is listed in the show ipv6 cam linecard {0–2}
port-set {0-3} output. Similarly, if there is more than one ECMP object
with a destination route that has a mask greater than 64, if the first 64 bits in
the destination routes of the ECMP objects are the same, only one route is
installed in CAM even though multiple ECMP path entries exist.
IPV6 is enabled
Link Local address: fe80::7686:7aff:feff:6f08
Global Unicast address(es):
10:10:10:1::8, subnet is 10:10:10::/48 (MANUAL)
Remaining lifetime: infinite
Global Anycast address(es):
Joined Group address(es):
ff02::1
ff02::2
ff02::1:ff00:8
ff02::1:ffff:6f08
ND MTU is 0
ICMP redirects are not sent
DAD is enabled, number of DAD attempts: 3
ND reachable time is 27000 milliseconds
ND base reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND router advertisements are sent every 200 to 600 seconds
ND router advertisements live for 1800 seconds
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
999