Parameters
encrypt-pass
clear-pass
Defaults
Disabled.
Command
ROUTER BGPV6-ADDRESS FAMILY
Modes
Command
Version
History
9.2(1.0)
8.2.1.0
Usage
The TCP session is authentication and hence prevents the data from being
Information
compromised.
network
Specify the networks for the BGP process and enter them in the BGP routing table.
Z9500
Syntax
network ipv6-address prefix-length [route-map map-name]
To remove a network, use the no network ip-address mask [route-map
map-name] command.
Parameters
ipv6-address
prefix-length
mask
route-map
map-name
530
Enter the encrypted password.
Enter the clear text password.
Description
Introduced on the Z9500.
Introduced
Enter the IPv6 address in the x:x:x:x::x format followed by the
prefix length in the /x format. The range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter the mask of the IP address in the slash prefix length
format (for example, /24). The mask appears in command
outputs in dotted decimal format (A.B.C.D).
(OPTIONAL) Enter the keywords route-map followed by the
name of an established route map. Only the following
ROUTE-MAP mode commands are supported:
•
match ipv6 address
•
match ipv6 next-hop
•
match ipv6 route-source
•
set ipv6 next-hop
If the route map is not configured, the default is deny (to
drop all routes).
Border Gateway Protocol