Dell Z9500 Reference Manual page 120

Hide thumbs Also See for Z9500:

Table of Contents

pattern pattern

sweep-interval

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

N: Do not validate reply data.

Y: Do validate reply data.

Default is No.

(IPv6 link-local address) Enter the outgoing interface for ping

packets to a destination link-local address.

(IPv4 only) Enter the IPv4 data pattern. Range: 0-FFFF.

Default: 0xABCD.

Enter the minimum size of datagram in sweep range. The

range is from 52 to 15359 bytes.

Enter the maximum size of datagram in sweep range. The

range is from 53 to 15359 bytes.

Enter the incremental value for sweep size. The range is from

1 to 15308 seconds.

(IPv4 only) Enter the outgoing interface for multicast packets.

Enter the IP address in A.B.C.D format.

For a Port Channel, enter the keyword port-channel

then a number. The range is from 1 to 128.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

EXEC Privilege

Introduced on the Z9500.

Introduced on the S4820T.

Added support for the outgoing-interface option for

link-local IPv6 addressing on the S4820T.

Added support for the outgoing-interface option for

link-local IPv6 addressing on the S4810.

Control and Monitoring