Bgp Add-Path - Dell Z9500 Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

In route maps used in the suppress-map parameter, routes meeting the deny

clause are not suppress; in other words, they are allowed. The opposite is also true:

routes meeting the permit clause are suppressed.

If the route is injected via the network command, that route still appears in the

routing table if the summary-only parameter is configured in the aggregate-

address command.

The summary-only parameter suppresses all advertisements. If you want to

suppress advertisements to only specific neighbors, use the neighbor

distribute-list command.

In the show ip bgp command, aggregates contain an 'a' in the first column and

routes suppressed by the aggregate contain an 's' in the first column.

When an aggregate address is denied using a peer's outbound route-map,

individual routes suppressed by the aggregate address are advertised to that peer.

The attribute-map corresponding to an aggregate address is applied during the

outbound update creation time; hence the value set in that attribute-map will not

be shown in the output of the show ip bgp aggregate route command.

bgp add-path

Allow the advertisement of multiple paths for the same address prefix without the new paths replacing

any previous ones.

bgp add-path [send | receive | both] path-count

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Border Gateway Protocol

Enter the keyword send to indicate that the system sends

multiple paths to peers.

Enter the keyword receive to indicate that the system

accepts multiple paths from peers.

Enter the keyword both to indicate that the system sends

and accepts multiple paths from peers.

Enter the number paths supported. The range is from 2 to

ROUTER BGP-address-family